Woods S15CD Betreibershandbuch PDF herunterladen (Seite 12)

12 Operation

MAN0290 (Rev. 6/16/2006)

SHEAR BOLT REPLACEMENT

 Never replace shear bolt or auger retaining bolt

with a different length, or grade. Always use a

grade 2 bolt as a replacement.

Remove input guard from around driveline.

Shear bolts are important for both safety and prevent-

ing damage to the digger. Their intended function is to

break when too much force is applied.

Always replace shear bolts at the gearbox input and

output shafts with manufacturer's part or one of the

same size, length and Grade 2 specification.

Hardened bolts or bolts that are too long can cause

accidents resulting in injury or death.

The roll pin (26) prevents the driveline from coming off

gearbox shaft if the shear bolt should fail.

Replace input shield after shear bolt replacement.

Figure 3. Shear Bolt Replacement

Shown Without Shield

PRE-OPERATION CHECKLIST

(OWNER RESPONSIBILITY)

___ Review and follow all safety rules and safety

decal instructions on pages 2 through 6.

___ Check that all safety decals are installed and in

good condition. Replace if damaged.

___ Check that all shields and guards are properly

installed and in good condition. Replace if dam-

aged.

___ Consult local utilities before digging. Know loca-

tion of and avoid contacting all underground

cables, pipelines, overhead wires and other haz-

ards in digging area.

___ Check that auger point and all cutting edges are

intact and in good repair.

___ Check that equipment is properly and securely

attached to tractor.

___ Make sure driveline spring-activated locking pin

slides freely and is seated firmly in tractor PTO

spline groove or gearbox PTO spline groove.

___ Set tractor PTO at correct rpm for your equip-

ment.

___ Check all lubrication points and grease as

instructed in “Service, lubrication information.”

___ Lubricate all grease fitting locations. Make sure

telescoping PTO shafts and universal joints are

lubricated.

___ Check that all hydraulic hoses and fittings are in

good condition and not leaking before starting

tractor. Check that hoses are not twisted, bent

sharply, kinked, frayed or pulled tight. Replace

any damaged hoses immediately.

___ Make sure tractor 3-point lift links do not interfere

with hydraulic hoses or driveline throughout full

turning range.

___ Check that all hardware and cotter pins are prop-

erly installed and secured.

___ Check attitude adjustment of auger.

___ Check and keep all bystanders away from equip-

ment working area.

___ Before starting engine, operator must be in trac-

tor seat with seat belt fastened. Place transmis-

sion in neutral or park, engage brake and

disengage tractor PTO.

26. 3/16 x 1-1/4 Roll pin

28. 5/16 NC Hex nut

29. 5/16 Lock washer

30. 5/16 NC x 2-1/2 Cap screw GR2

34. 1/2 NC x 3 Cap screw GR2

35. 1/2 Lock washer

36. 1/2 NC Hex nut



1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

Woods S15CD Betreibershandbuch Seite 12

Kommentare zu diesen Handbüchern